Pore Characterization
Minimum pressure required to force gas through the largest pore of a liquid-saturated porous medium defines the rating for a filtration substrate. This value, called the bubble point, provides a non-destructive method for verifying the maximum pore size in synthetic membranes or non-woven fabrics. It relies on the surface tension of the wetting liquid and the diameter of the capillary to establish a correlation with particle retention.
Measurement Procedure
Testing involves submerging a sample in a liquid of known surface tension and gradually increasing air pressure on one side. The moment the first continuous stream of bubbles appears marks the bubble point of the material.
Filter Selection
Industrial filtration systems use this metric to ensure that a membrane meets the specific micron rating needed for high-purity processing. A lower than expected value signals either a defect in the membrane surface or an incorrect pore size distribution that would allow contaminants to pass.
Structural Integrity
Surface energy of the polymer and the wetting characteristics of the fluid both impact the accuracy of the reading. If the liquid does not fully wet the pores, the resulting bubble point will be falsely high, leading to an overestimation of the filter efficiency. Temperature control remains necessary during testing because surface tension varies with heat.
Consistency in the test fluid ensures that results across different batches of technical textiles are comparable.