Extrusion Obstruction
Accumulation of solid particles or degraded polymer inside the narrow channels of a spinning plate halts the flow of synthetic filaments. Spinneret clogging results in uneven yarn diameter or complete breakage during the extrusion process. This buildup typically occurs at the exit face where the molten material meets the air.
Quality drops immediately when the flow through even one hole is restricted.
Particle Accumulation
Impurities in the raw polymer chips or carbonized material from stagnant zones are the primary causes of the blockage. Pigments used for dope dyeing also contribute to spinneret clogging if the particle size is too large. Filters located just before the spinning plate attempt to catch these solids before they reach the orifices.
Despite these screens, micro particles can still lodge in the capillaries over time.
Fibre Deviation
Distorted flow at the exit of the hole causes the filament to emerge at an angle rather than straight down. This behavior leads to a defect known as kneeing or dripping. A partial spinneret clogging event reduces the mass of the filament, which creates a thin spot in the resulting yarn.
These thin spots weaken the fabric and cause streaking in the dyed finished product.
Maintenance Cycle
Regular cleaning of the spinning hardware is required to maintain a consistent extrusion rate. Operators use ultrasonic baths or high temperature ovens to remove the hardened polymer from the holes. Replacing a plate with spinneret clogging issues minimizes the amount of waste generated during a production run.
Production stops for these changes, so mills monitor pressure build-up to predict the best time for service.