Kinematic Interval
Mechanical rotation angles measured across a machine main shaft define the operational duration allocated for weft transit across an open warp shed. Measured in degrees of shaft revolution, the loom timing window opens when the warp shed separates sufficiently for weft entry and closes when descending harness frames trap the pick. This angular window typically spans one hundred and twenty to one hundred and sixty degrees within a single three-hundred-and-sixty-degree rotational cycle.
Pick arrival must occur entirely inside this designated angular zone to prevent mechanical interference from closing heddles or the advancing reed.
Coordinate Phasing
Shedding motions, insertion nozzles or rapier heads, cutting shears, and beat-up mechanisms must synchronize to precise shaft angles. The loom timing window requires exact phasing with main nozzle blow start, relay jet group sequences, and profile reed motion. Advancing the opening angle permits earlier pick launch but demands wider shed lift, which increases warp tension and end breakages.
Delaying the window closure invites collision between the advancing filling yarn and the converging warp sheets.
Arrival Tolerance
Arrival timing of the inserted filling yarn is captured by electronic optical detectors located at the far selvage. When the yarn tip clears the far edge within the designated loom timing window, the main drive maintains continuous velocity. Early arrivals indicate excessive pneumatic propulsion or low yarn friction, which causes the pick to rebound into the fabric body.
Late arrivals indicate insufficient air pressure, obstructed shed openings, or package sloughing, prompting an immediate brake application to prevent a short pick.
Speed Limitation
Machine operating speed depends on the angular space remaining for filling insertion as cycles accelerate. At high revolutions per minute, the loom timing window contracts in absolute milliseconds, even if shaft degree allocations remain unchanged. Coarse yarns, which possess high linear mass and drag, struggle to clear wide reed widths within these compressed millisecond windows.
Adjusting the loom timing window to accommodate heavy counts involves widening shed lift cams, which inevitably increases tensile strain across the running warp.